Teknorep 200 Fine Correction Mortar

Product description
It is a cement based, single component, polymer modified thin repair mortar with increased adherence.

Usage areas
• In the repair of concrete that comes out after the mold is taken during all kinds of construction,
• In mineral surface repair,
• All kinds of industrial reinforced concrete structures,
• In engineering structures such as subways, highways, dams,
• In repair, repair and reinforced concrete reinforcement projects,
• In filling the air bubbles and spaces,
• On surfaces with thick repair mortar applied,
• It is used in the repair of prefabricated elements.

Features and Advantages
• It is easy to apply.
• It is suitable for use with spraying and trowel.
• It is resistant to freezing and thawing.
• It is non-corrosive and non-toxic.
• It is used to obtain a smoother surface in fine repairs.

Application Instructions
Surface Quality: The surfaces must be clean, smooth, solid, free of all kinds of dust, oil, dirt, rust, mold oil, detergent, etc. Weak parts on the surface should be removed.

Surface Preparation: Cement slurry and weakened parts should be removed, and there should be no materials such as oil, dirt and rust on the surface. Absorbent surfaces should be pre-wetted, but no puddles should remain. When the adherence primer is required, TEKNO AD is applied with a brush and TEKNOREP 200 repair mortar is applied on it before it dries.

Mixing: 4.0 - 5.0 liters of clean, clear water taken from normal ambient temperature is poured into a clean container that is free of any substance preventing adhesion. TEKNOREP 200, which is in powder form and in a 25 kg bag, is poured into the container filled with water. It is mixed with a low speed mixer until a homogeneous mixture without lumps is obtained. Mixing time is minimum 5 minutes. should be. The mortar obtained at the end of the process takes 3 minutes. rest and again for 2 minutes. should be mixed until it becomes homogeneous. After the material has reacted, water should not be added and mixed again.

Application Notes / Limitations
• It should be protected from sun, rain and frost for the first 3 hours in outdoor applications.
• Reaction times in cement based products are affected by ambient and ground temperatures. Reaction times are shortened in hot environments and longer in cold environments.
• Do not add more water than recommended.
• Do not use below the minimum allowable temperature for the material to complete its setting. Low temperatures will slow down the socket, and high temperatures will accelerate the socket. Workability time will also vary depending on temperatures.
• During the application of the product, work clothes in accordance with the rules of work and worker health should be worn, and appropriate glasses and masks should be used.
• If necessary, clover is pulled to ensure surface smoothness. Applications with a wall thickness of more than 30 mm should be done in layers.
• After the application, it should be protected against adverse weather conditions such as direct sunlight, strong wind, high air temperature (over +35°C), rain and frost. Before the product is fully cured, hands should be cleaned with water and detergent.
• Equipment should be cleaned with water immediately after the application, before it hardens. After the product hardens, it should be cleaned by mechanical methods.