Teknorep 100 Flex Correction Paste

Product description
It is a white cement based, single component, polymer reinforced, highly stable surface smoothing and filling putty.

Usage areas
• It is used for leveling exposed concrete elements with all kinds of surface defects. It is suitable for exterior.
• All kinds of industrial reinforced concrete structures,
• In engineering structures such as subways, highways, dams,
• In repair, repair and reinforced concrete reinforcement projects,
• Parking lots, shopping malls,
• It is used in the repair of prefabricated elements.

Features and Advantages
• It is mixed with water.
• Provides smooth surface finish.
• It has excellent adherence on concrete and plastered surfaces.
• It creates a crack-free appearance on large surfaces.
• No need for primer and easy to apply.
• Does not swell with water like gypsum plasters.

Application Instructions
Surface Quality: Surfaces should be clean, smooth, solid, free from all kinds of dust, oil, dirt, rust, mold oil, detergent, etc. Weak parts on the surface should be removed.

Surface Preparation: Cement slurry and weakened parts should be removed, and there should be no materials such as oil, dirt and rust on the surface. Absorbent surfaces should be pre-wetted, but water puddles and drops should not remain.

Mixing: 7.5 liters of clean, clear water taken from normal ambient temperature is poured into a clean container that is free of any substance preventing adhesion. Teknorep100 Flex, which is in powder form and in a 20 kg bag, is poured into the container filled with water. It is mixed with a low speed mixer until a homogeneous mixture without lumps is obtained. Mixing time is minimum 5 minutes. should be. The mortar obtained at the end of the process takes 3 minutes. rest and again for 2 minutes. should be mixed until it becomes homogeneous. After the material has reacted, water should not be added and mixed again.

Application Notes / Limitations
• It should be protected from sun, rain and frost for the first 3 hours in outdoor applications.
• Reaction times in cement based products are affected by ambient and ground temperatures. Reaction times are shortened in hot environments and longer in cold environments.
• Hot mixing water should be used in cold environments.
• In hot environments, cold mixing water should be used.
• During the application of the product, work clothes in accordance with the rules of work and worker health should be worn, and appropriate glasses and masks should be used.
• The prepared mortar is applied to the concrete surface by scraping with a steel trowel. Then the required amount for leveling is applied to the surface. Applications with a wall thickness of more than 2 mm should be done in layers.
• After the application, it should be protected against adverse weather conditions such as direct sunlight, strong wind, high air temperature (over +35°C), rain and frost. Before the product is fully cured, hands should be cleaned with water and detergent.
• Equipment should be cleaned with water immediately after the application, before it hardens. After the product hardens, it should be cleaned by mechanical methods.
• It can only be used as stripping in the sheathing system. Thick applications can cause cracking.