Teknomer 400 W Water Based Bitumen Insulation

Product description
It is a one-component, highly elastic, water-based, waterproofing material modified with special polymers.

Usage areas
• It is also used in retaining and curtain walls, building foundations.
• Against ground moisture and leakage waters,
• On reinforced concrete terrace roofs,
• Insulation of galleries, drainage and waste water channels and collectors,
• It is used in the isolation of open utility water tanks and pools against water and humidity.

Features and Advantages
• Ready to use.
• Does not contain solvent, does not shine.
• It is applied by brush, roller or airless spray gun.
• It does not sag on vertical concrete surfaces.
• It has no UV resistance.
• It is cold applied, does not require heating and thinning.
• It dries very quickly.
• It creates a seamless and uninterrupted isolation layer.
• It is water based and shows good adhesion even on damp surfaces.

Application Instructions
The surfaces must be clean, smooth, solid, free from all kinds of dust, oil, dirt, rust, mold oil, detergent, etc. If there is segregation in the concrete, damaged and loose parts should be discarded and weak pieces should be removed. If there are cracks or cavities on the floor or wall where the application will be made, they should be repaired with appropriate TEKNOREP repair mortars. TEKNOMER 400 W application should be started after 3-4 days.

The surface to be insulated must be dry. If there is a puddle or ponding, it should be removed. Before applying TEKNOMER 400 W, if there is dilatation of the structure, first of all, the dilatation must be insulated using TEKNOMER PAH TAPES and TEKNOMER 400 D. Later, the insulation of dilatations is more difficult and costly.

Application Notes / Limitations
• Foreign materials should not be added and should not be diluted with water.
• It should not be applied under direct sunlight.
• It should be applied in two layers.
• It should not be applied in the rain.
• Rain, etc., until the newly applied material completes its hardening. must be protected against weather conditions.
• TEKNOMER 400 W is mixed in a clean container that is free of any substance preventing adhesion or in its own container. It is mixed with a low speed mixer until a homogeneous mixture without lumps is obtained. Mixing time should be at least 5 minutes.
• The product, whose mixture is completed and ready for application, is applied to the surface with a stiff bristle brush or spraying machines. After the material completes its reaction, the second layer is applied in the vertical direction of the first layer application. Waiting time between coats is at least 1 hour. After the application of the first layer, when there is no trace on the fingers in the manual control, other layers can be passed. If desired, carrier glass fiber can be used as reinforcement between floors.
• Since the product has no UV resistance, heat insulation boards, protection boards, geotextile felt, etc. must be applied after the application. should be covered with
• After the application, it should be protected against adverse weather conditions such as direct sunlight, strong wind, high air temperature (over +35°C), rain and frost. Before the product is fully cured, hands should be cleaned with water and detergent.
• Equipment should be cleaned with TEKNO THINNER immediately after the application, before it hardens. After the product hardens, it should be cleaned by mechanical methods.