Teknomer 400 2K Antiroot Waterproofing Material

Product description
It is a two component, root impermeable, polymer bitumen-rubber based, high elasticity, crack sealant, applied only from the positive side, waterproofing material.

Usage areas
• Where root impermeability is required,
• Green terrace applications,
• In basement and curtain walls,
• On mineral surfaces in contact with the soil,
• It is used in all kinds of reinforced concrete structures below and above ground.

Features and Advantages
• Resistant to plant roots. It prevents the coating from being damaged by plant roots.
• It can be applied with a brush, trowel or airless spray gun.
• Does not sag on vertical surfaces.
• It maintains its elasticity even at low temperatures.
• It can be applied on all mineral surfaces such as concrete, stone, brick, briquette.
• It provides waterproofing without joints, joints and against all kinds of water and moisture effects.
• Solvent-free, non-flammable/non-flammable.
• It can be applied on dry and slightly damp surfaces.
• It can bridge cracks.

Application Instructions
Surface Quality: The surfaces must be clean, smooth, solid, free of all kinds of dust, oil, dirt, rust, mold oil, detergent, etc. If there is segregation in the concrete, damaged and loose parts should be discarded and weak pieces should be removed. If there are cracks or cavities on the floor or wall where the application will be made, they should be repaired with appropriate TEKNOREP repair mortars. TEKNOMER 400 2K Antiroot application should be started after 3-4 days.

Surface Preparation: The surface to be insulated must be dry. If there is a puddle or ponding, it should be removed. Before applying TEKNOMER 400 2K Antiroot, if there is dilatation of the structure, first of all, the dilatation must be insulated using Teknomer Chamfer Tapes and TEKNOBOND 400 D.

Application Notes / Limitations
• Foreign materials should not be added.
• It should not be applied under direct sunlight.
• It should be applied in two layers.
• It should not be applied in the rain.
• The product should not be diluted with water.
• Rain, etc., until the newly applied material completes its hardening. must be protected against weather conditions.
• Teknomer 400 2K Antiroot is added to component B on top of component A in a clean container or in its own container that is free from any substance preventing adhesion. It is mixed with a low speed mixer until a homogeneous mixture without lumps is obtained. Mixing time should be at least 5 minutes.
• Teknomer 400 Primer or Teknomer 400 2K Antiroot liquid component is diluted 1/10 and applied to the surface to be applied. After waiting between 30 minutes and 1 hour, the product, whose mixture is completed and ready for application, is applied to the surface with a hard bristle brush or spraying machines. After the material completes its reaction, the second layer is applied in the vertical direction of the first layer application.
• Waiting time between coats is at least 5 hours. After the application of the first layer, when there is no trace on the fingers in the manual control, other layers can be passed. If desired, carrier glass fiber can be used as reinforcement between floors.
• Since the product has no UV resistance, heat insulation boards, protection boards, geotextile felt, etc. must be applied after the application. should be covered with
• After application, it should be protected against adverse weather conditions such as direct sunlight, strong wind, high air temperature (over +35°C), rain and frost. Before the product is fully cured, hands should be cleaned with water and detergent.
• Equipment should be cleaned with Tekno Thinner immediately after the application, before it hardens. After the product hardens, it should be cleaned by mechanical methods. It is mixed until a homogeneous mixture without lumps is obtained. Mixing time should be at least 5 minutes.
• The product must be protected before landfilling.